Inicio > Asistencia técnica > Base de conocimientos

Wire Map Schemes - DTX CableAnalyzer

The Outlet Configuration must match an appropriate test standard i.e. USOC Single-Pair requires the test limit Voice - 2 Pair. If it does not, you will see the following Error Screen.  1000BASE-TX Crossover has been added to Version 1.4. (Current Version is 2,78)
 
NEW to Version 1.4 (Current Version is 2,78) will not allow you to select an inappropriate Outlet Configuration. 
 

Incompatible Test Cable

                                     
 		                 
 
 
Wire Map USOC Single Pair		  
Wire Map USOC Two Pair
 
 		  
 
 
Wire Map Ethernet Two Pair		  
Wire Map Ethernet Two Pair Crossed
 
 		  
 
 
Wire Map ATM/TP-PMD Straight		  
Wire Map ATM/TP-PMD Crossed
 
 		  
 
 
Wire Map Crossover		  
 Wire Map 1000 BASE-T Crossover
       
  Wire Map Rollover    

 
For safety reasons, the DTX CableAnalyzer will report all wires that are connected. For example, you may select Ethernet as your Outlet Configuration. This is a Two-Pair Wire Map but if all pairs are connected, then all pairs will be displayed as shown below. 
 

Wire Map Ethernet